You can also temporarily bypass the pressure switch by using a jumper wire to make good contact with both terminals on the switch. To see if the switch is working right, you can check it for voltage with a power meter or multi-meter. The first switch in the loop is the pressure switch, which controls the flow of water into the unit. You will probably need to consult your pool heater manual to identify these switches. Each of the safety switches in this circuit must be enabled for the heater to turn on and begin to generate heat. Pool heaters are set up with a basic circuit known as the control loop. If the filter isn’t the problem, the next most likely cause of your pool heater problem is a disabled safety switch. Fortunately, this is an easy fix all you have to do is remove and clean the filter and make sure all the valves are open. A dirty filter or pump basket can restrict the water flow so much that the heater simply can’t work. The most common cause of swimming pool heaters refusing to start up is a dirty swimming pool filter. However, you can expand your troubleshooting abilities with these simple tips. Most people’s troubleshooting abilities are limited to checking that the pool heater is plugged in if it is an electric heater or has fuel if it is a gas heater. When you’ve been looking forward to a nice relaxing swim in a warm pool, it can come as quite a shock and a disappointment to discover that your pool heater won’t start. Tips for troubleshooting your pool heater.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |